Ultrasonic assisted creep feed grinding of Inconel 718

D. Bhaduri, S.L. Soo, D. Novovic, D.K. Aspinwall, P. Harden, C. Waterhouse, S. Bohr, A.C. Mathieson, M. Lucas

Research output: Contribution to journalArticlepeer-review

35 Citations (Scopus)
340 Downloads (Pure)

Abstract

The paper details the effects of depth of cut and vibration amplitude when ultrasonic assisted (US) creep feed grinding Inconel 718 with an open structured alumina based wheel. The workpiece was actuated at a constant frequency (∼20.5kHz) via a block sonotrode attached to a 1kW piezoelectric transducer-generator system. A full factorial experimental array comprising 12 tests was conducted involving variation in depth of cut (0.1, 0.5 and 1.0mm), amplitude of vibration (high and low) and grinding condition (with and without vibration). Wheel speed and table feed were fixed at 30m/s and 600mm/min respectively for all tests. Application of ultrasonic vibration resulted in reductions in vertical (F) and horizontal (F) force components by up to 28% and 37% respectively, however greater wheel wear (30-60% lower G-ratio) occurred under hybrid operation due to increased grit/bond fracture. SEM micrographs of the slots machined with US assistance revealed higher levels of side flow/ploughing in comparison to standard creep feed ground specimens. Additionally, more overlapping grit marks were visible on surfaces subject to ultrasonic assisted grinding. Increasing amplitude of vibration produced lower grinding forces (up to 30% for F and 43% for F ) but higher workpiece surface roughness (up to 24%). Topographic maps of grinding wheel surface replicas indicated that use of US vibration generally led to an increase in the number of active cutting points on the wheel.
Original languageEnglish
Pages (from-to)615-620
Number of pages6
JournalProcedia CIRP
Volume6
DOIs
Publication statusPublished - 1 Jan 2013

Fingerprint

Dive into the research topics of 'Ultrasonic assisted creep feed grinding of Inconel 718'. Together they form a unique fingerprint.

Cite this