Strength assessment of Al-Humic and Al-Kaolin aggregates by intrusive and non-intrusive methods

Research output: Contribution to journalArticle

Authors

  • Rodrigo Moruzzi
  • Pedro Grava da Silva
  • Soroosh Sharifi
  • Luiza C. Campos
  • John Gregory

Colleges, School and Institutes

External organisations

  • Sao Paulo State University
  • University College London

Abstract

Resistance to breakage is a critical property of aggregates generated in water and wastewater treatment processes. After flocculation, aggregates should ideally keep their physical characteristics (i.e. size and morphology), to result in the best performance possible by individual separation processes. The integrity of aggregates after flocculation depends upon their capacity to resist shear forces while transported through canals, passages, apertures, orifices and other hydraulic units. In this study, the strength of Al-Humic and Al-Kaolin aggregates was investigated using two macroscopic measurement techniques, based on both intrusive and non-intrusive methods, using image analysis and light scattering based equipment. Each technique generates different information which was used for obtaining three floc strength indicators, namely, strength factor (SF), local stress from the hydrodynamic disturbance (σ) and the force coefficient (γ) for two different study waters. The results showed an increasing trend for the SF of both Al-Humic and Al-Kaolin aggregates, ranging from 29.7% to 78.6% and from 33.3% to 85.2%, respectively, in response to the increase of applied shear forces during flocculation (from 20 to 120 s−1). This indicates that aggregates formed at higher shear rates are more resistant to breakage than those formed at lower rates. In these conditions, σ values were observed to range from 0.07 to 0.44 N/m2 and from 0.08 to 0.47 N/m2 for Al-Humic and Al-Kaolin, respectively. Additionally, it was found that for all studied conditions, the resistance of aggregates to shear forces was nearly the same for Al-Humic and Al-Kaolin aggregates, formed from destabilized particles using sweep coagulation. These results suggest that aggregate strength may be mainly controlled by the coagulant, emphasizing the importance of the coagulant selection in water treatment. In addition, the use of both intrusive and non-intrusive techniques helped to confirm and expand previous experiments recently reported in literature.

Details

Original languageEnglish
Pages (from-to)265-273
Number of pages9
JournalSeparation and Purification Technology
Volume217
Early online date15 Feb 2019
Publication statusPublished - 15 Jun 2019

Keywords

  • Aggregates, Floc resistance, Image analysis, Flocculation

ASJC Scopus subject areas