Extraction of Borage Seed Oil by Compressed CO2: Effect of Extraction Parameters and Modelling

Research output: Contribution to journalArticle

Colleges, School and Institutes

Abstract

The extraction of borage seed oil using compressed CO2 was studied on a pilot plant apparatus with the aim of optimise plant performance and collect data for scale-up purposes. The seeds were pre-treated by flaking them into 0.3 mm flake prior to the extraction tests for achieving quantitative recovery of the oil. Effects of extraction pressure (200-300 bar) and temperature (10-55 degrees C), solvent flow rate (7.5-12kg/h) and bed length (0.25-0.50m) were examined. As a major factor, oil solubility in CO2 controlled the extraction rate until 70% of the oil had been extracted, and then intraparticle resistances appear to have dictated the rate of extracting the remaining fraction of the oil. A mathematical model, based on the evidence that the oil is partially exposed to solvent after the pre-treatment of the seed, was used to correlate the experimental data. Average deviation between measured and calculated oil yields was 8%. The best-fitting values of the model parameters, namely fraction of readily accessible oil (f(k)), solid phase mass transfer coefficient (k(s)) and specific interfacial area (alpha) were 0.7, 2.8 x 10(-7) m/s and 350 m(-1), respectively. (c) 2006 Elsevier B.V. All rights reserved.

Details

Original languageEnglish
Pages (from-to)68-73
Number of pages6
JournalJournal of Supercritical Fluids
Volume41
Issue number1
Publication statusPublished - 1 May 2007

Keywords

  • borage seed, seed oils, modelling, extraction, carbon dioxide