Effect of fuel injector deposit on spray characteristics, gaseous emissions and particulate matter in a gasoline direct injection engine

Research output: Contribution to journalArticle

Authors

  • Changzhao Jiang
  • Roger Cracknell
  • Jens Krueger-Venus

Colleges, School and Institutes

External organisations

  • Department of Mechanical Engineering
  • Shell Global Solutions (Deutschland) GmbH

Abstract

For modern gasoline direct injection (GDI) engines, injector deposit is a concern because it can cause changes to the spray characteristics and lead to deterioration in fuel economy and exhaust emissions. In this study, in order to examine the link between spray variation and engine emissions deterioration due to injector deposit accumulation, 8 new injectors were installed on a GDI engine and run through a deposit accumulation process which included 6 cold starts and a 30-h steady state engine test at a speed of 2000 rpm and load of 5 bar break mean effective pressure (BMEP). One representative injector was examined before and after the deposit accumulation tests in order to understand the impact of deposit on the spray. Results showed that, at the end of the deposit accumulation test, the pulse width of the injectors stabilized at a level which was about 1.5% higher than at the start and the fuel consumption remained almost identical. High magnification and borescope imaging indicated that a significant amount of deposit had formed on the outer surface of the injector tip. However, Scan Electronic Microscope (SEM) imaging of the injector hole showed that, at this level of fouling, some deposit was present on the counterbore, while the nozzle hole was nearly completely unaffected. The deposit on the counterbore caused a 2.21% drop of the injector fuel flow rate at 150 bar injection pressure. Penetration lengths and mean droplet sizes of all jets increased significantly. As for the impacts of the varied spray characteristics on the engine emissions, unburnt hydrocarbons (HC) and particulate matter (PM) emissions significantly increased while other gaseous emissions (e.g. CO, NOx, CO2) only changed slightly.

Details

Original languageEnglish
Pages (from-to)390-402
Number of pages13
JournalApplied Energy
Volume203
Early online date21 Jun 2017
Publication statusPublished - 1 Oct 2017

Keywords

  • Deposits, Gasoline direct injection, Particulate matter, Spray characteristics